|
WarmSeats (c)
The DIY Leader of Automotive Seat Heaters
 
WarmSeats Carbon Fiber Element Seat Heater Kit
The Seat Heater elements are paper-thin, and install between the seat cover material and the seat cushion. They are water-resistant and pose NO problem with damp winter cloths, spilled beverages, or wet pets! They are NOT visible and do not detract from the finish or look of your vehicle's factory upholstery.
A small three-position switch (off, low, high) is installed in the lower seat trim panel for a "factory" type appearance. All wiring and the heat element controller are concealed below the seat or run under the door sill trim plate, carpeting, etc. It is fully compatible with existing power seats or multi-adjustable "sport" type seats finished in cloth, vinyl, or leather.
The advantages of This Seat Heater
Consistent and controlled warmth (up to 121 degrees) with carbon technology.
Heating level is adjustable to suit personal requirement.
Element can be trimmed to fit any seat.
Single seat application possible.
OEM specifications.
The seat heater system gives you all the features and quality you would expect from an original equipment installation.
The application of carbon technology ensures the even spread of warming to both the seat back and the cushion.
Feel comfortable in minutes.
High quality materials guarantee reliability and long life.
Elegant switch with fingertip control.
The heat can be adjusted to two levels to suit your needs.
SWITCHES & HARNESSES
The Heater kit comes with the following switch;
HIGH/OFF/LOW
"Hi" setting: 108 - 121 degree (+/- 4 degrees).
"Lo" setting: 98 - 108 degree (+/- 4 degrees).
HEATER ELEMENTS
Type: Carbon Fiber / Felt Panels
Each panel 11" (266mm) X 20" (500)
Element can be trimmed to the desired Length or altered to accommodate plastic seat.
Power: 12V / 4.7 Amp/60W Heat
Warranty: Manufacturers Three Year / 36,000 miles on parts only.
Universal fit
Sold in PAIRS (for 2 seats)
KIT COMES WITH INSTALLATION INSTRUCTIONS & PLUG & PLAY PRE-WIRED HARNESS, SWITCH & RELAY, ONLY 2 WIRES TO CONNECT (12V switched source and Ground)
|
